The RC Hammers are designed for use for drilling exploratory wells in quarries, open pit mines, coal pit mines, coal where faster exploration is required.

The RC Hammers can be operated on high pressure air. Its drill cycle is designed to make this drill extremely effective. At high pressures like 350 PSI and above, the RCD performs well in applications where high water yields/back pressure is encountered.

Reverse Circulation Hammers
Description/ Hammer Size 4 ½” 5”
Weight (K.g.) 62 67
Length (inches) 49 43.5
Bore (inches) 4 ½ 5
Hammer Length with Bit (inches) 51 45.5
Reverse Circulation Bits
Description/ Bit Size 4 ½” 5” 5 ½” 6”
Weight (K.g.) 13 17 18.5 24
Length (inches) 14 13 14.4 16
SL NO DESCRIPTION QTY PART NUMBER
1 CYLINDER/WEAR SLEAVE 1 AC1602
2 O - RING 4 AO0106
3 ADOPTER PIPE 1 AH1201
4 CIRCLIP 1 AL0105
5 TOP SUB 1 AC1601
6 WASHER 1 AO0202
7 CHECK VALVE PLUNGER 1 AC1108
8 OIL SEAL 1 AO0011
9 CHECK VALVE SPRING 1 AL1201
10 STEEL MAKEUP RING 1 AL0706
11 RUBBER MAKEUP RING 1 AO0203
12 CHECK VALVE GUIDE 1 AC1119
13 SAMPLE TUBE UPPER 1 AC0006
14 SAMPLE TUBE LOWER 1 AC0007
15 DISTRIBUTOR 1 AC1502
16 PISTON 1 AC1701
17 INNER SLEEVE 1 AC1702
18 DRIVE SUB BUSH 1 AC0308
19 `O` RING 1 AO0105
20 BIT RETAINER RING 1 AC1111
21 SHROUD 1 AC1110
22 DRIVE SUB 1 AC1603
23 BIT 1 AC1608

SALIENT FEATURE:- 

  • Significantly reduces sample contamination.
  • For Used in hard rock application.
  • Valves less DTH Hammer Design.
  • It is not reversible wear sleeve (Cylinder)
  • It can drill 450, 600 & 900.
  • Less fuel Consumption /Feet Drilling.
  • High rate of penetration while utilising les air.
  • Excellent under water Characteristics